Belts squeaking on Tekna Auto 2007 |
Post Reply
|
Page <123> |
| Author | |
mdvineng
Established Member
Joined: 11 May 2011 Location: United Kingdom Status: Offline Points: 103 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 August 2011 at 14:33 |
|
Cheers John, not too hard on the wallet then, compared to an alternator etc regards
dave s |
|
|
both motorcycle wheels drifting with the power on feels great
|
|
![]() |
|
Guests
Guest
|
Post Options
Thanks(0)
Quote Reply
Posted: 04 August 2011 at 17:25 |
|
Thats not bad for a main dealer
|
|
![]() |
|
jondoc
New Member
Joined: 02 August 2011 Location: United Kingdom Status: Offline Points: 13 |
Post Options
Thanks(0)
Quote Reply
Posted: 04 August 2011 at 18:42 |
|
Yes I thought it was ok, if a bit low. But the staff attitude and the way they treated me ,gave me the confidence to book in with them. I`ll give my verdict next week; it`s booked in for Wednesday. John |
|
![]() |
|
jondoc
New Member
Joined: 02 August 2011 Location: United Kingdom Status: Offline Points: 13 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 August 2011 at 18:27 |
|
All done. No problems at all. Belt change done. Half hour drive with the mechanic to find my phantom rattle at 1500 revs; just before `down` gear change. Thats gone now. The mechanic said tyres are close to limit; front 3mm - rear 4mm. No pressure to buy from them at £106 each. A good all round experience and £53 as quoted. Thanks again for all your input. Cheers, John
|
|
![]() |
|
graham49d
New Member
Joined: 07 May 2010 Location: United Kingdom Status: Offline Points: 12 |
Post Options
Thanks(0)
Quote Reply
Posted: 10 August 2011 at 21:27 |
|
Hi Jondoc
I have a Tenkna Auto from new last Feb and the belt sqealed in wet/damp weather and was adjusted on first service. It has done it again since and it will be on "the list" when it goes in for its next service. Expect to still hear the squeal when your new belt is fitted and it gets a bit damp!! |
|
|
Graham
|
|
![]() |
|
mdvineng
Established Member
Joined: 11 May 2011 Location: United Kingdom Status: Offline Points: 103 |
Post Options
Thanks(0)
Quote Reply
Posted: 11 August 2011 at 09:48 |
|
Glad it's sorted, very wet here in manchester this morning and my belt squealed in protest at having to rotate, in the 5 seconds it lasted i managed to do some quick diagnostic checks just to confirm; switch on and off high current loads to change the alternator loads and switch between nuetral and drive and also blip the throttle, all produced a change in the squeal without moving the car an inch, thus confirming belt slip, drove 3 metres and slip gone for the rest of the journey. I will be checking the belt tension when it's dry enough to lie down on the floor though. Settings for old belt on a HR engine are with a 10kgf on the bottom run- deflection limits 4.8<5.3mm, new belt 4.2<4.5mm. This is a 1.6 auto with aircon. regards dave s |
|
|
both motorcycle wheels drifting with the power on feels great
|
|
![]() |
|
PhilT
New Member
Joined: 19 October 2010 Location: United Kingdom Status: Offline Points: 27 |
Post Options
Thanks(0)
Quote Reply
Posted: 27 August 2011 at 09:43 |
|
I agree the belt needs tensioning seems to be a common problem on notes usually happens in damp conditions, but for a quick fix..got to be carefull mind! just runcar and on tick over touch the belt with an old candle for a few minutes that usually works..as I said BE CAREFULL WHEN YOU DO THIS!! do not get any clothing or hair or something caught...health and safety!!! I think I saw a youtube clip on this once.
|
|
![]() |
|
PhilT
New Member
Joined: 19 October 2010 Location: United Kingdom Status: Offline Points: 27 |
Post Options
Thanks(0)
Quote Reply
Posted: 22 October 2011 at 13:52 |
|
Just had an MOT and had this squealing noise for awhile, mechanic I always have says its nothing... a new belt costing £11 did not say how much he would charge but he put on some belt dressing and its fine again, although he said after another possibly 2,000 miles it would be ready for a new belt. So the 50 odd quid mentioned here is 40 plus for fitting? Many say do not use the belt dressing spray as it attracts dirt and dust onto the belt and thus spreads to the flywheel itself, but for a quick fix and not using too much or repeated too often is okay I think. the big test will be in the damp or rainy mornings which I have not had yet.
|
|
![]() |
|
Guests
Guest
|
Post Options
Thanks(0)
Quote Reply
Posted: 22 October 2011 at 20:07 |
|
40 is about the going rate for an hours labour in the south east it can be as high as £100 an hour
|
|
![]() |
|
The Therapist
New Member
Joined: 01 December 2011 Status: Offline Points: 1 |
Post Options
Thanks(0)
Quote Reply
Posted: 01 December 2011 at 18:33 |
|
The early Notes had an issue with the compound materials used in the manufacture of the belts. Nissan now make them from a different material because of this. A new Nissan belt will eliminate the problem.
|
|
![]() |
|
Post Reply
|
Page <123> |
|
Tweet
|
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |